User manual

24
741.011 | 12.18
EN
10.3 Setting the time
Note
The time must be once more set to the correct values if power is removed for a longer
period of time. After this, the same operating mode is displayed as was active previous
to the removal of power.
√
flashes.
1. Press SET. The hours display flashes.
2. Press  to change the hour.
3. Press SET. The minute flashes.
4. Press  to change the minute.
5. Press SET. The change is adopted.
10.4 Setting the system
Note
The systems are described in Section 5.4, p. 11.
√
Syst
flashes.
1. Press SET. The number of the current system flashes.
2. Press  to select a different system.
3. Press SET. The change is adopted.
10.5 Setting the functions
√
F unc
flashes.
X Continue as described in Section 11, p. 25.
10.6 Setting the parameters
Note
Details on the parameters are provided in Section 12, p. 39.
√
P
ara
flashes.
1. Press SET. P:01 (Parameter number) flashes.
2. Press  to display a different parameter.
3. Press SET. The value of the parameter is displayed, associated components flash in
the system graphics.
4. Press SET. The parameter value flashes.
5. Press  to change the value.
6. Press SET to adopt the change.
7. Press ESC. The parameter number is displayed (flashing).
8. If necessary, repeat steps 2 – 7.
10.7 Resetting to factory settings
√ flashes, RESEt is displayed (RE and SEt alternately).
1. Press and hold SET for 5 seconds.
2. A progress display is shown for a few seconds. After this the reset is finished.
3. Continue as described in Section 6, p. 12.