Cut Sheet

Accessories — Conduit Termination,
Cutting and Joining
F-78
Non-Metallic Rigid Conduit, Fittings and Accessories
PVC Conduit Cutters
PVC
Conduit
E940
Coupling
E996
Box Adapter
PVC
Conduit
E943
Terminal
Adapter
E943_W
Flat Washer
or O-Ring
Locknut
or Bushing
Apply solvent cement to shoulder and shank of box adapter and insert
through knockout from inside the enclosure. Push coupling over the shank
of the box adapter, tight against the enclosure wall. Rotate the coupling
about one-half turn while installing, and hold in position for a few seconds
to permit setting of solvent cement. The coupling is now ready for the
conduit to be installed. Only the shoulder of the box adapter extends
inside the enclosure.
Method 1. Permanent Termination
If a “wet location” as defined in Article 100 of the NEC
®
construction is
required, place a flat washer or O-ring over the threads of the terminal
adapter, securely against the shoulder. Insert the adapter threads through
knockout and secure using either a standard locknut or threaded bushing.
If watertight construction is not required, eliminate flat washer.
Method 2. Separable Termination
For fast, smooth field cuts of
1
⁄2"
through 1" Non-Metallic Rigid Conduit,
Flex-Plus
®
Blue
™
ENT and Carflex
®
liquidtight flexible non-metallic conduit.
Hand-held cutter makes fast, square,
smooth field cuts on Non-Metallic Rigid
Conduit from
1
⁄2" through 1
1
⁄4". Produces
burr-free cut with no shavings. Fits into
pocket or pouch.
For clean cuts of conduit
1
⁄2" through 2".
CAT. NO. SIZE (IN.) STD. CTN.
CC120B 810
CAT. NO. SIZE (IN.) STD. CTN.
CC125 912
CAT . NO. SIZE (IN.) STD. CTN.
CC122 17
1
⁄2 1
Medium Cutter
Small Cutter
Large Cutter
Terminating Non-Metallic Rigid Conduit is quick and easy utilizing
either of the methods indicated below. Terminations may be made
in any electrical box or enclosure using standard size knockouts
or drilled holes.
Fittings and Adapters for Terminating
Non-Metallic Rigid Conduit