Use and Care Manual

INSTRUCTIONS FOR THE 4-WAY LOADING
CARTRIDGE LOADING (See Fig. 1)
(a) Remove the gun head from the container tube.
(b) Draw back the plunger handle entirely.
(c) Insert open end of cartridge into container tube and push all the way in. Remove the seal or pull
tab end from the cartridge.
(d) Reassemble the gun head to the container tube. Press the locking plate and release the piston rod.
Pull down the plunger handle.
LOADING WITH FILLER PUMP (See Fig. 2)
(a) Draw back the plunger handle entirely.
(b) Insert filler plug into the filler pump socket. Make sure plug is the type that fits the socket.
(c) Operate the filler pump to fill the container tube.
(d) Disconnect the grease gun from the filler pump.
(e) Press the locking plate and release the piston rod. Pull down the plunger handle.
BULK FILLING (See Fig. 3)
(a) Remove the gun head from the container tube.
(b) Draw back the plunger handle entirely. Fill bulk grease into empty container tube.
(c) Reassemble the gun head to the container tube. Press the locking plate and release the piston rod.
Pull down the plunger handle.
SUCTION FILLING (See Fig. 4)
1. Remove the Tube from the top of the Front Housing
2. Submerge the open end of the Tube approximately 2 inches into the grease container (not included).
3. Slowly, pull back and fully extend the Handle to draw grease upward into the Tube. When the
Handleis fully extended, lock it into place with the Locking Plate.
4.
Carefully, reassemble the Tube to the top on the Head. Press the Locking Plate and release the Handle.
Press the Handle in as far as it will go.
40599
AIR GREASE GUN
Fig. 4: Suction FillingFig. 3: Bulk FillingFig. 1: Cartide Loading
Fig. 2:
Loading with Filler Pump
For Customer Service, Call 1-800-348-5004
or e-mail [e-mail]
40599 04/2017