Full Product Manual

ManualsBrandsSteel Core ManualsAutomotivePortable Pro Steel Hubs and Wheel Balancer with Bubble Level for Heavy-Duty Rims and Tires of Cars/Trucks

For Customer Service, Call 1-800-348-5004

or e-mail customerservice@focus-ontools.com

42301 12/2017

PORTABLE WHEEL BALANCER

42301

*Actual product may vary slightly

Please carefully read and save these instructions before attempting to assemble, maintain, install, or operate this product.

Observe all safety information to protect yourself and others. Failure to observe the instructions may result in property

damage and/or personal injury. Please keep instructions for future reference.

For warranty purchases, please keep your dated proof of purchase. File or attach to the manual for safe keeping.

This product can expose you to chemicals including

LEAD/CADMIUM, which is known to the State of

California to cause cancer and birth defects or other

reproductive harm. For more information go to

www.P65Warnings.ca.gov.

WARNING

Summary of content (4 pages)

PAGE 1
42301 PORTABLE WHEEL BALANCER WARNING This product can expose you to chemicals including LEAD/CADMIUM, which is known to the State of California to cause cancer and birth defects or other reproductive harm. For more information go to www.P65Warnings.ca.gov. *Actual product may vary slightly Please carefully read and save these instructions before attempting to assemble, maintain, install, or operate this product. Observe all safety information to protect yourself and others.
PAGE 2
Specifications Hub Capacities 1-1/2 IN. to 4 IN. Diameter Type of Wheels Light Truck and Automobile Safety Warnings 1. Do not use the Wheel Balancer until properly trained. This product is intended for use by properly trained and experienced personnel only. If you are not familiar with the proper and safe operation of a wheel balancer, do not use until trained. 2. Keep work area clean and well lit. Cluttered areas invite injuries. 3. Keep children away. Children must never be allowed in the work area.
PAGE 3
Assembly 14 Part numbers used below refer to the Parts Diagram and Part Number Listing on page 5. 1. Thread Nut (10) onto threaded end of Shaft (9). Then slide Flat Washer (10) onto threaded end of Shaft. 2. Insert the threaded end of the Shaft (9) into the Base (12). 10 3. Use Lock Washer (13) and Nut (10) from underneath 11 to secure the Shaft. 12 4. The Balancing Cone Set (7) rests on top of the tip located on top of the Shaft (9).
PAGE 4
Parts List and Assembly Diagram Part 1 2 3 4 5 6 7 8 9 10 11 12 13 14 Description Flange Set Rod and Spring Set Screw (M2.5 x 20) Level Washer Level Spring Balancing Cone Set Retaining Pin Shaft Nut (M20 x 1.5) Flat Washer Base Lock Washer Shaft Receiver Qty. 1 1 4 3 1 1 1 1 4 1 2 1 1 1 1 3 4 5 6 2 7 8 14 TO PREVENT INJURY FROM TOOL FAILURE: Do not use damaged equipment. If damaged or loose parts are noted, have the problem corrected before further use. 1.