Installation Guide

Floating Surface Adjustable Bracket Installation Guide & Warranty Information 6
Mounting Options continued
Options 2 and 3: Mounting Bracket to Wall
Reference the numbers below with the diagram
1 – Install 2x4 cross braces between wall studs to support bracket.
The bracket can be mounted on stud or any location on cross
braces. Use bracket as template to locate cross braces.
2 – If single level countertop, notch top of 2x4 cap ¼" by 2 ⅛". Cut
¼” radius on inside wall. If two level, make additional notches on
back of wall ½" deep by 2 ⅛" so backsplash or nished surface
can cover bracket. (see number 6 in lower image)
3 – Make sure bracket ts tightly on wall surface and there is
1
⁄
16
″ gap
(very important) from top of bracket to top of wall. If not, remove
material in notch until bracket is
1
⁄
16
″ from top surface of wall.
4 – Attach bracket to wall using 2 – ¾" wood screws, one in bottom
hole and one in middle hole.
5 – Go to page “Adjusting Set Screws and Installing Countertop.”
5
Single Level Wall Mount
Two Level Wall Mount
Locking Wedge
¼"