Instruction Manual

Page 1 of 3 10/17/07 (AM)

PARTS LIST:

Driver/Left Sidebar

Driver/Left Double Nut Plate

Passenger/Right Sidebar

Passenger/Right Double Nut Plate

Driver/Left Front Mounting Bracket

10-1.50mm x 30mm Hex Head Bolts

Passenger/Right Front Mounting Bracket

10mm Lock Washers

Driver/Left Rear Mounting Bracket

10mm ID x 21mm OD x 1.5mm Flat Washers

Passenger/Right Rear Mounting Bracket

10mm Hex Nuts

Driver/Left Front Support Bracket

½” x 2” Hex Head Bolts

Passenger/Right Front Support Bracket

½” Lock Washers

Driver/Left Rear Support Bracket

½” ID x 1 3/8” OD x 3/32” Flat Washers

Passenger/Right Rear Support Bracket

INSTALLATION INSTRUCTIONS

SIDEBAR

98-10 FORD RANGER SUPER CAB 4 DR

PART #

Driver Side Front

Mounting Bracket

Passenger Side Front

Mounting Bracket

Driver Side Rear

Mounting Bracket

Passenger Side Rear

Mounting Bracket

Driver Side Rear

Support Bracket

Passenger Side Rear

Support Bracket

Driver Side Front

Support Bracket

Passenger Side Front

Support Bracket

Driver

Side Double Nut Plate

Passenger

Side Double Nut Plate

PAGE 1
INSTALLATION INSTRUCTIONS SIDEBAR 98-10 FORD RANGER SUPER CAB 4 DR PART # PARTS LIST: 1 1 1 1 1 1 1 1 1 1 Driver/Left Sidebar Passenger/Right Sidebar Driver/Left Front Mounting Bracket Passenger/Right Front Mounting Bracket Driver/Left Rear Mounting Bracket Passenger/Right Rear Mounting Bracket Driver/Left Front Support Bracket Passenger/Right Front Support Bracket Driver/Left Rear Support Bracket Passenger/Right Rear Support Bracket Driver Side Front Mounting Bracket Driver Side Rear Support Bracket 1
PAGE 2
PROCEDURE: 1. REMOVE CONTENTS FROM BOX. VERIFY ALL PARTS ARE PRESENT. READ INSTRUCTIONS CAREFULLY BEFORE STARTING INSTALLATION. 2. From underside of vehicle, locate the three factory holes (one large, two small) in the driver side cross frame by the front body mount. With the welded nuts facing up, insert the smaller end of the driver side Double Nut Plate through large hole in the frame and orient it to front smaller hole (Figure 1). 3.
PAGE 3
Fig 3 Insert Rear Support Bracket through here Fig 4 10mm x 30mm Hex Bolt 10mm Lock Washer 10mm Hex Nut 10mm Flat Washers Rear Support Bracket Make sure these holes line up Fig 5 10mm x 30mm Hex Bolts 10mm Lock Washer 10mm Hex Nut 10mm Flat Washers Fig 6 10mm x 30mm Hex Bolt 10mm Lock Washer 10mm Hex Nut 10mm Flat Washers Fig 7 ½” x 2” Hex Head Bolt ½” Lock Washer ½” Flat Washer Fig 8 ½” x 2” Hex Head Bolt ½” Lock Washer ½” Flat Washer Page 3 of 3 10/17/07 (AM)