INSTALLATION INSTRUCTIONS ELEVATION FRONT BUMPER 2017 FORD SUPER DUTY F250-350
ELEVATION FRONT BUMPER 2017 FORD SUPER DUTY F250-350 PARTS LIST: 1 1 1 2 1 1 2 8 14 Elevation Front Bumper Assembly Driver/left Frame Bracket Passenger/right Frame Bracket Plastic Plugs for license plate mount Driver/left Upper U-Bracket (OEM fog light) Passenger/right Upper U-Bracket (OEM fog light) Lower U-Brackets (OEM fog light only) 12mm x 50mm Bolt Plates 12-1.75mm x 50mm Hex Bolts 36 22 22 2 4 2 4 4 4 12mm x 32mm x 3mm Flat Washers 12mm Lock Washers 12-1.75mm Hex Nuts 8-1.
ELEVATION FRONT BUMPER 2017 FORD SUPER DUTY F250-350 5. Select the driver/left Frame Bracket. Slide the Bracket over the end of the frame. Line up the slots in the sides of the Bracket with the holes in the frame. Select (4) 12mm Bolt Plates. Insert the Bolt Plates into the open end of the frame and out through the Bracket. Attach the Bracket to the Bolt Plates with (4) 12mm Flat Washers, (4) 12mm Lock Washers and (4) 12mm Hex Nuts, (Figures 8 & 9). Leave hardware loose at this time. 6.
ELEVATION FRONT BUMPER 2017 FORD SUPER DUTY F250-350 Lower frame extension (Fig 1) On models with fog lights, unplug wire harness from back of light (Fig 2) Release clips attaching the wire harness for fog lights if equipped (driver side) (Fig 3) Remove plastic air dam from bumper Front (Fig 4) Remove outer bumper support brackets between frame and bumper (arrow) Front (Fig 5) Remove plastic cover around tow hook WARNING! Do not remove bumper bolts unless the bumper is properly supported on blocks o
ELEVATION FRONT BUMPER 2017 FORD SUPER DUTY F250-350 Driver/left Side Installation Pictured WARNING! Do not crawl under bumper unless the bumper is properly supported on blocks or stands or the bumper may fall. Front (Fig 6) Remove bumper bolts (driver side pictured) (Fig 7) Remove tow hook assembly and lower frame extension (not pictured-see Fig 2) (4) 12mm Flat Washers (4) 12mm Lock Washers (4) 12mm Hex Nuts Front (4) 12mm Bolt Plates Front (Fig 8) Insert Bolt Plates into open end of frame.
ELEVATION FRONT BUMPER 2017 FORD SUPER DUTY F250-350 Driver/left Side Installation Pictured (4) 12mm x 50mm Hex Bolts (8) 12mm Flat Washers (4) 12mm Lock Washers (4) 12mm Hex Nuts Front (Fig 10) Attach top of Bracket to top of frame Front (Fig 11) Attach top of Bracket to top of frame WARNING! Do not crawl under bumper unless the bumper is properly supported on blocks or stands or the bumper may fall.
ELEVATION FRONT BUMPER 2017 FORD SUPER DUTY F250-350 Driver/left Side Installation Pictured 8mm x 20mm Hex Bolt (2) 8mm Flat Washers 8mm Nylon Lock Nut Front (Fig 15) Push plastic plugs into holes in Bumper for license plate if required Front (Fig 16) Optional OEM fog light installation (light not included).