Owner manual

ManualsBrandsSteele Products ManualsEquipmentSP-PM200M

TECHNICAL DATA

UNPACKING

PACKING LIST

Note:

1 Top Handle

2 Centre Handle pieces

2 Lower Handle pieces

8 Knobs, 8 Bolts, 8 Washers

2 C-clips

1 Reel Mower Body

• Carefully remove the parts from the box.

• Inspect the parts carefully in order to verify that no breakage or

damage occurred during shipping.

• Do not discard the packing material until all parts have been

examined.

• If any parts are damaged or missing, call 888-896-6881 for

assistance.

Cutting Path........................................................20" (50.8 cm)

Height Adjustments.........................1 3/4 - 2 3/4" (4.5 - 7 cm)

Wheels...............................................6" (15 cm) rear wheels,

10" (25 cm) front wheels

Weight...........................................................27 lbs (12.35 kg)

- 2 -

Summary of content (5 pages)

PAGE 1
-2- Note: • Carefully remove the parts from the box. • Inspect the parts carefully in order to verify that no breakage or damage occurred during shipping. • Do not discard the packing material until all parts have been examined. • If any parts are damaged or missing, call 888-896-6881 for assistance. PACKING LIST 1 Top Handle 2 Centre Handle pieces 2 Lower Handle pieces 8 Knobs, 8 Bolts, 8 Washers 2 C-clips 1 Reel Mower Body UNPACKING Cutting Path........................................................
PAGE 2
-3- • Never place hands, fingers, or feet inside the reel. Although this mower is not powered by a motor, the reel spins when the wheels turn, and it is sharp enough to cause serious injury. • Never mow the grass when it is wet enough to be slippery. • Do not use the reel mower while barefoot or while wearing sandals. • Walk slowly. Do not run. Always make sure of your footing when using the reel mower. • Do not intentionally strike or ram trees, fences, etc.
PAGE 3
-5- 1.The cutting height of the 20” (50.8 cm) Reel Mower can be adjusted from 1 3/4 to 2 3/4” 1 (4.5 to 7 cm) by moving the height adjusment levers (1) to the desired position. The height adjusment levers are located next to the smaller wheels. Fig.3 2. In order to set the mower to its lowest cutting position, pull the height adjustment levers (1) on both sides to their highest positions. 3.
PAGE 4
-7- NOTE: Use a 10 MM socket or wrench to adjust the cutting bar. Use an industrial or valve lapping compound of between 100 and 240 grit on the blades in order to ensure that all traces of compound are removed. Lubricate the axle and pinion with a light film of wheel bearing grease. CHECKING THE ADJUSTMENTS 1. Turn mower upside-down. 2. Insert a piece of paper between the cutter bar and the reel blades, and carefully turn the reel wheels by hand. 3.
PAGE 5
PARTS LIST -9- 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 21 Item 1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 PARTS LIST - 10 - Description Left housing support Right housing support Cutting reel Top push handle Centre handle pieces Lower handle Pin Bearing Gear wheel Housing Long shaft Cutting bar Cutting bar adjustment bolt Cutting bar adjustment Spring Shaft Cutting height adjustment Rear Wheel Rubber cover Front wheel Wheel cover Cutting bar adjustment locking nut nut Foam