Owner manual

Owner’s Manual
2
Detergent Connection/Usage
12
OPERATION
Avoid working on hot surfaces or in direct sunlight to minimize the chances of the chemical damaging
painted surfaces. Damage may occur to painted surfaces if the chemical is allowed to dry on the surface.
Hold the nozzle far enough away from surface to prevent damage to the surface.
2. Allow chemical to remain on the surface for a short time before rinsing.
3. Rinse with clean water under high pressure. On a vertical surface, first rinse from the bottom up, then
rinse from top down. Hold nozzle 6 to 8 inches from the work surface at a 45° angle using the flat spray as
a peeling tool rather than a scrub brush.
APPLICATION OF WAX
1. Immediately after cleaning, apply wax. Place injection tube in container of wax.
2. Apply the wax sparingly in an even layer. Apply to wet surfaces from bottom up for even distribution and to
avoid streaking.
3. Remove the suction tube from the wax bottle rinse off the surplus wax.
NOTE: If surplus wax is not removed, a hazy finish may result.
4. Wipe dry to reduce water spotting.
END OF OPERATION
When you have completed use of chemical injection system, remove tube from container. Continue to run in
low pressure position and inject clean water through the tube and injection system by placing end of tube in a
container of clean water. Continue to run until it is thoroughly cleaned.
MAINTENANCE
Connections
Connection on pressure washer hoses, gun and spray wand should be cleaned regularly and lubricated with
the manufacturers recommended grease to prevent leakage and damage to the 0-rings.
NOZZLE
Clogging of the nozzle causes the pump pressure to be too high, cleaning is immediately required.
A nozzle cleaner must only be used when the spray
wand is disconnected from the gun or personal injury
may occur.
1. Seperate the wand from the gun.