Manual

Generator
Assembly
Wheel Kit Installation
Start by installing the
rubber floor mounts
I
onto the support teg
as shown.
Note: The leg should
be installed on the
same side as the putt
handle.
This is what the leg
looks like when it is
installed.
Here is the hardware required to install
the support leg. Place a block of wood
under the generator so that you don't
have to hold it up while trying to install
the teg.
Place the support leg under the frame.
Push the bolt thru the frame and thru
the leg. Thread a nut onto the bolt.
Tighten with a wrench.
The wheels should be installed on the side
opposite to the handle.
Place a block of wood under the
generator so that you don't have to hold it
up while trying to install the axle.
Push the two axle mount brackets onto
each side of the axet. Place the axte under
the unit.
Thread two bolts thru the tubular frame
and thru the axle mounting plates. Thread
a nut onto the bolt and tighten.
Slide the wheels
onto the axle. Place
a washer over the
wheel
Push the cotter pin thru
the axle and bend it
backwards as shown
Your generator is now
mobile. Enjoy!
/
14