Manual

3.5KWGenerator

Operation

Powering 120/240Volt AC Tools And Equipment:

1 Prior to powering tools and equipment, make sure the generator's rated

voltage, and amperage capacity (two 120V-25AMPs out/ets/one 240V- 12.SAMPs

out/et) is adequate to supply all electrical loads that the unit will power. If

powering exceeds the generator's capacity, it may be necessary to group one

or more of the tools and/or equipment for connection to a separate generator.

CAUTION. ATTEMPTING TO POWER SENSITIVE

ELECTRONIC EQUIPMENT WITHOUT THE USE OF AN

APPROVED LINE CONDITIONER MAY CAUSE DAMAGE TO

THE EQUIPMENT. ALL-POWER IS NOT RESPONSIBLE FOR

ANY DIRECT OR INDIRECT DAMAGE CAUSED BY FAILURE TO

USE AN APPROVED LINE CONDITIONER.

2. Start the machine

3. Once the generator is running, simply connect the power cords of 120/

240 volt AC powered tools and equipment into the 120/240 volt AC dual

outlets.

Note: The Generator features an circuit breaker with the function of

(_ overload to the AC circuit in case of an overload or

protector protect

short circuit.

4. When finished using the generator, turn the engine power switch to its

"OFF" position. Turn the fuel valve to its "OFF" position.

5. Disconnect all electrical powered tools and equipment from the

generator's 120/240 volt AC duel outlets.

6. After the engine and generator have completely cooled, store generator

in a safe, clean, dry location (if not already installed).