Manual

Adjusting the Cutting Height
Adjusting the cutting height may bring you into
contact with the moving blade, causing sedous
injury.
° Stop the engine and wait for all moving pads
to stop.
* Do not put your fingers under the housing
when adjusting the cutting height.
Figure 8
If the engine has been running, the muffler will
be hot and can severely burn you. Keep away
from the hot muffler.
Adjust the cutting height as desired. Set all four wheels
to the same height.
Note: To raise the mower, move the cutting height
levers forward; to lower the mower, move the all the
cutting height levers rea_ard (Figure 7).
1
F_gure 9
Note: If the mower does not start after several
attempts, contact an Authorized Service Dealer.
2
Stopping the Engine
Service _nterva[: Before each use or daily
To stop the engine, release the blade control bar
(Figure 10).
low
Figure 7
1. Raise the mower 2. Lower the mower
Note: The cutting height se_ings are (_ra_); (_ra);
Starting the Engine
1. Hold the blade control bar (Figure 8) against the
handJe.
1. Blade control bar
Figure 10
Important: When you release the blade control bar,
both the engine and Made should stop within 3
seconds. If they do not stop properly, stop using
your mower immediately and contact an Authorized
Service Dealer.
5