Manual

Anothermethodof reducing risks of freezedamageis to drainyour pressurewasherasfollows:
1. Stop the pressure washer and detach supply hose and high pressure hose. Squeeze the trigger of the
discharge gun to drain all water from the wand and hose.
2. Restart the pressure washer and let it run briefly about 5 seconds) until water no longer discharges from
the high pressure outlet.
ENGINE STORAGE
When the pressure washer is not being used or is being stored for more than a month follow these
instructions:
1. Replenish engine oil to upper level.
2. Drain gasoline from fuel tank, fuel line, fuel valve and carburetor.
3. Pour about one teaspoon of engine oil through the sparkpiug hole, pull the recoil starter slowly until you
feel increase pressure which indicates the piston is on its compression stroke and leave it in the position.
This closes both the intake and exhaust valves to prevent the inside of the cylinder from rusting.
4. Cover the pressure washer and store in a clean, dry place that is well ventilated away from open flame or
sparks.
NOTE: The use of a fuel additive, such as STA-BIL, or an equivalent, will minimize
the formulation of fuel gum deposits during storage.
Technical Specification
Maximum Inlet Pressure
Up To 90 PSi
RPM 3600 RPM
Temperature OF Pumped Fluids Up To 80 F
Inlet Ports (2) 1/2 inch BSP
Discharge Ports (2) 1/2 inch BSP
Weight 92.4 Ibs.
Engine Oil 10W-30
HP 6.5HP
Fuel Unleaded Gas