User's Manual

REMOTE BEEP & VIBRATE SELECTION

The LCD pager remote BEEPS and VIBRATES when it receives a signal from the vehicle. The Beeps and

Vibration are selectable (on/off). To enter program mode,

1. Press VEH Button on the side of the remote control 5 times.

2. The remote will beep and the AM or PM display will begin flashing.

3. Press the Start button to choose the mode of “Beep ON/OFF & Vibrate ON/OFF”.

4. Press the VEH Button to Save and Exit Setup or wait 8 seconds, the LCD light will turn off.

Mode 1: The remote beeps once and vibrates: this indicates “Beep ON & Vibrate ON”.

Mode 2: The remote beeps once without vibration; this indicates “Beep ON & Vibrate OFF”.

Mode 3: The remote only vibrates, without beep; this indicates “Beep OFF & Vibrate ON”.

Mode 4: The remote does not vibrate or beep; this indicates “Beep OFF & Vibrate OFF”.