User's Manual

STATUS LED

LED Operation: (Optional, requires Installation of LED)

LED will flash when locking your doors with remote.

LED will remain solid in Valet Service Mode.

REMOTE ENGINE CONTROL

REMOTE START Button Press Selection (Option # 6):

To eliminate the possibility of accidentally starting the vehicle, there are (3) options for button press selection. This

option allows you to change whether the Remote starter is activated by a:

4. Double button - ½ second presses.

5. *Single ½ second press (Default).

6. Press and Hold 2 seconds.

*Default = 1 single press*

REMOTE ENGINE STARTING - SUCCESSFUL START:

1) Press the remote start button for at least 1/2 second (*default). Parking lights flash once, return solid, and the

Ignition/Acc circuits turn on.

2) After a few seconds the Starter Motor engages. The parking lights and Acc circuits will turn off while cranking.

3) Engine Starts and Runs. Parking Lights and Acc turns back on, and the doors lock.

4) Engine will remain running for programmed run time until reset with Brake pedal. If needed, the engine can be

turned off with remote transmitter by pressing and releasing the Start button.

Note: When the vehicle remote starts, the 2-Way Pager will display the engine run in place of the Clock.

AFTER

IGN

STARTER

THEN

FLASH 1X

SOLID

SEC.

PRESS START