data sheet

Speedcleaner RX 5 | 2014_V1
Page 12 / 14
EN
cleaner.
Install the stabilizier
Recommend to use this standing nut on the pool cleaner for using in
the pool which has the steps in order to avoid the turn upside down
of pool cleaner.
Align the hole oft he stabilizer tot he hole and the localizer on the top
cover.
Put screw trough the whole and fasten
Apply and fasten the screw to secure stabilizer in position on the
cover. Repeat same assembly for the other 3 stabilizers.
Trouble Shooting
Symptom
Possible reason
Corrective actions
Cable twisting
or coils up
Cable was not fully
released
Unplug power line, re-
lease cable
Excess cable in the
pool
Remove excess cable
out oft he pool and en-
sure the proper length of
cable on pool.
Gets stuck on main
drain cover
Turn off pool filter system
Cleaner does
not reach all
pool areas
Power supply was
wrong positioned.
Place power supply on
position so that cleaner
can reach all areas
Pool filter and pump
is on
Turn off pool filter system
Cable not long
Release cable
enough in pool.
Cleaner does
not climb walls
properly
Filter bag filled with
debris
Replace filter bags
Algae on walls
Brush walls
Water temperature is
too high/low
Optimally water tempera-
ture between 10 – 32 °C
Brush worn
Contact dealer, replace
brushes
Cleaner too light –
trapped air
Turn off cleaner, exhaust
air inside cleaner
Unsuitable pH Level
Check level between 7.0
– 7.4
The nut on sliding
block is not in proper
position or loose
Change back to original
position, or contact local
vendor
Cleaner does
not work
Power cord not con-
nected well
Plug power cord an cable
line
Damaged during
transportation
Contact local vendor
Local rated voltage is
not suitable for
cleaner
Contact local vendor
Cleaner does
not sink
Air inside cleaner
Turn off cleaner, ensure
there is no air inside
cleaner and let cleaner
sink to bottom of pool
Roller/belt cut
Debris blocked in
driving system
Contact local vendor
Cleaner float
out of water
Cleaner climb too
high, air in cleaner
Turn off cleaner, re-
exhaust air. Contact
dealer o fit happens fre-
quently
Cleaner da-
maged
Wrong operation
Contact local vendor
Warranty in relation to operation safety and reliability is only accept-
ed from the manufacturer under the following conditions:
 The pool cleaner is operated according to the specifica-
tions of the user.
 For repairs, only original spare parts are used (wearing
parts are not subject to warranty).
Consequential damages
For damage to the product, caused by failure to follow the manuel
recommendations, we can not pay.
WEEE EU-Directive
Please respect the European Union regulations and help to protect
the environment.
Return non-working electrical equipment to a facility appointed by
your municipality that properly recycles electrical and electronic
equipment. Do not dispose them in unsorted waste bins.
Pay attention tot he direction of
the stabilizer
Localizer