Specifications

Starting the CC121 and Cubase
14 Operation Manual
Starting the CC121 and Cubase
Once installation (page 10) has been successful, the CC121 can be used at any time by following the simple proce-
dure below, allowing the computer to recognize the CC121.
1 Exit Cubase if it has already been started.
Cubase cannot recognize the CC121 if you turn on the power of the CC121 after starting Cubase. Make sure
to start Cubase after turning on the power of the CC121.
2 Start the CC121 by executing the instructions of "Turning the Power On and Off" on page 8, then
press the [STANDBY/ON] switch of the CC121 to set it to the ON position ( ).
IMPORTANT
Make sure to use the same USB terminal as the one used in the installation procedure when you connect the
CC121 to the Windows computer again. If you connect the USB cable to a different terminal, you will have to install
the USB-MIDI driver again.
3 Start Cubase.
The CUBASE READY lamp (LED) on the front panel lights, indicating that the computer recognizes the
CC121 and the Link functions between the CC121 and Cubase are available.
NOTE
·You can connect or disconnect the AC power adaptor to/from the CC121 while the [STANDBY/ON] switch is set to ON.
CAUTION
• As soon as you turn off the power of the computer connected to the CC121, make sure to press the [STANDBY/
ON] switch of the CC121 to set it to the STANDBY position.