User manual

219
The Control Room (Cubase only)
The Control Room Mixer
Click
Activates the metronome click.
• Use the Click Level and Click Pan controls to set the volume and the pan position
of the metronome click for this channel.
Listen Enable for Output
This button activates the Listen bus function for the Headphone output. If this button
is not enabled, the Listen bus is not routed to the Headphones channel.
Listen Level
This control determines how loud Listen bus signals are when they are routed to the
Headphone output.
Channels Section
In the Channels section, the speaker arrangement of the Control Room channel
according to the Main Mix bus is shown.
Each speaker icon works as solo button for that channel. The “+” icon solos the LFE
channel. You can use the solo functions to test your multi-channel speaker system
and make sure that the correct channels are routed to the speakers.
Solo Channels buttons
The three solo buttons allow you to solo the left and right channels, the front channels,
or the rear channels.
Listen to Solo Channels on Center Channel button
When this button is activated, all soloed speakers are heard in the center channel, if
available. If a configuration does not contain a center speaker, the channels are
distributed equally to the left and right.
Listen to Surround Channels on Front Channels button
When this button is activated, the rear channels are soloed and routed to the front
speakers.