User manual

39
VST Connections
Editing operations
Ö You do not have to begin renaming with the topmost selected entry. The renaming will
start from the bus where you edit the name, will go down the list to the bottom and
then continue from the top until all selected busses have been renamed.
Changing the port assignment for a single bus
To change the port assignment for a single bus, you proceed as when you added it:
Make sure that the channels are visible and click in the Device Port column to select
ports.
Changing the port assignment for multiple busses
To change the port assignment (or the output routing in case of groups/FX channels)
for multiple entries in the Bus Name column at the same time, you need to select the
corresponding busses first.
• To assign different ports to the selected busses, press [Shift], open the Device
Port pop-up menu for the first selected entry (i.
e. the topmost bus) and select a
device port.
All subsequent busses are automatically connected to the next available port.
• To assign the same port to all selected busses, press [Shift]-[Alt]/[Option], open
the Device Port pop-up menu for the first selected entry (i.
e. the topmost bus) and
select a device port.
Ö You can also set all selected busses or channels to Not Connected.
Removing busses
To remove a bus you do not need, select it in the list, right-click and select Remove
Bus from the pop-up menu, or press [Backspace].
!
Cubase only: Exclusive ports (e. g. ports already assigned to Control Room channels)
will be skipped!