User manual

445
Remote controlling Cubase
The Remote Control Editor
Control Type Settings for Switches
The following options are available for switches:
• Momentary
The assigned function is active for as long as you keep the switch pressed.
• Increasing Stepwise
Pressing the switch steps through the available settings until the maximum is
reached.
• Decreasing Stepwise
Pressing the switch steps through the available settings in reverse order until the
minimum is reached.
• Increasing Stepwise (cycle)
Pressing the switch steps through the available settings, starting over with the
minimum value when the maximum is reached.
• Decreasing Stepwise (cycle)
Pressing the switch steps through the available settings in reverse order, starting
over with the maximum value when the minimum is reached.
• Smart Switch
This changes between two states every time you press the switch, like an On/Off
button. Furthermore, if you keep the switch pressed, you enter Momentary mode,
that is, the corresponding function stays active for as long as the button is
pressed.
Invert Control Value
This inverts the control state/value.
Hide Control When Inactive
Hides plug-in parameters when they are inactive or disabled.
Assigning Parameters to Controls
1. Click the L button on the toolbar to activate Learn mode for the editor.
2. In the editor, select the control that you want to assign to a plug-in parameter.
A colored frame around a control shows that this control has the Learn focus.
3. Click on a parameter on the plug-in panel.
This assigns that parameter to the control.
• You can also double-click on a control in the editor to open the list of available
plug-in parameters, and click a parameter to assign it to the control.