User manual

602
The Project Logical Editor (Cubase only)
Setting up filter conditions
Searching for elements at certain positions
1. Select “Position” in the Filter Target pop-up menu.
This allows you to find elements starting at certain positions, either relative to the
start of the project or within each bar.
2. Open the pop-up menu in the Condition column and select the desired condition.
For positions, the following options are available:
• If you select any condition other than the Range, Bar Range, Cursor, Loop or
Cycle options, you set up a specific position (in PPQ, seconds, samples, or
frames) in the Parameter 1 column. Use the Bar Range/Time Base column to
specify the time base. Note that the position for Bar Range is measured in ticks
related to the start of the bar.
Here, the Project Logical Editor will find all elements at the PPQ position 5.1.1. in the project.
• If you select Inside Range or Outside Range in the Condition column, you set the
start position of the range in the Parameter 1 column and the end position in the
Parameter 2 column. You can also change the time base using the Bar
Range/Time Base column.
The Project Logical Editor will then find all elements inside or outside this position
range.
Condition An element will be found if it…
Equal …has the exact same value as set up in the Parameter 1 column.
Unequal …has any value other than the one set up in the Parameter 1
column.
Bigger …has a value higher than the one set up in the Parameter 1
column.
Bigger or Equal …has a value that is the same as or higher than the one set up in
the Parameter 1 column.
Less …has a value lower than the one set up in the Parameter 1 column.
Less or Equal …has a value that is the same as or lower than the one set up in
the Parameter 1 column.
Inside Range …has a value that is between the values set up in the Parameter 1
and Parameter 2 columns. Note that Parameter 1 should be the
lower value and Parameter 2 the higher.
Outside Range …has a value that is not between the values set up in the
Parameter 1 and Parameter 2 columns.
Inside Bar Range …is within the “zone” set up in the Bar Range/Time Base column,
in each bar within the current selection.
Outside Bar Range …is outside the “zone” set up in the Bar Range/Time Base column,
in each bar within the current selection.
Before Cursor …is before the song Project position.
Beyond Cursor …is after the song Project position.
Inside Track Loop …is inside the set track loop (see “The independent track loop
function” on page 374).
Inside Cycle …is inside the set cycle.
Exactly Matching
Cycle
…exactly matches the set cycle.