User manual

631
The Project Browser (Cubase only)
Editing tracks
Note that if you have not performed any automation or opened an automation track,
the Browser will only contain the audio data.
The following parameters are available for the different items:
The list columns for audio events
Parameter Description
Name Allows you to change the name of the event. Double-clicking the
waveform image to the left of it opens the event in the Sample Editor.
File The name of the audio file referenced by the event’s audio clip.
Start The start position of the event. If the event belongs to an audio part,
you cannot move it outside the part.
End The end position of the event.
Snap The absolute position of the event’s snap point. Note that adjusting
this value will not change the position of the snap point within the
event – instead it is another way of moving the event!
Length The length of the event.
Offset This determines “where in the audio clip” the event starts. Adjusting
this value is the same as sliding the contents of the event in the
Project window, see
“Sliding the contents of an event or part” on
page 77.
You can only specify positive Offset values, because the event
cannot start before the start of the clip. Likewise, it cannot end after
the end of the clip. If the event already plays the whole clip, the Offset
cannot be adjusted at all.
Volume The volume of the event, as set with the Volume handle or on the info
line in the Project window.
Fade In
Fade Out
The length of the fade-in and fade-out areas respectively. If you use
these settings to add a fade (where there previously was none), a
linear fade will be created. If you adjust the length of an existing fade,
the previous fade shape will be maintained.
Mute Click in this column to mute or unmute the event.
Image Displays a waveform image of the event inside a gray box
corresponding to the clip. The image is scaled according to the width
of the column.