User manual

Table Of Contents

NOTE

If you want to input bars from the caret position, make sure that you have selected Start

of Selection from the menu.

5. Click Insert Bars.

RESULT

The number of bars specied is input.

During note input, bars are input from the caret position.

If you selected Start of Selection, bars are input directly after a selected barline, and directly

before a selected note, bar, or time signature.

TIP

Another way to add bars is by choosing a note value, such as a whole note when in a 4/4 time

signature, and pressing Space repeatedly during note input.

RELATED LINKS

Bars on page 491

Inputting time signatures with the panel on page 216

Inputting bars/beats with the system track

You can add bars/beats within existing music, for example, if you decide you want to repeat

several bars before the next section. You can add whole bars and you can add just a few beats.

NOTE

You cannot use the system track during note input.

PREREQUISITE

The system track is shown.

PROCEDURE

1. In the system track, select the region whose duration you want to insert.

For example, if you want to insert two bars, select two bars in the system track immediately

before where you want the two new bars to be input.

2. Click Add above the system track.

Add button above the system track The Add button is highlighted when you hover

over it

RESULT

The rhythmic duration selected in the system track is added immediately after the end of the

selection. Existing music after the selection is pushed back after the inserted bars/beats.