User manual

Table Of Contents

PROCEDURE

1. In Write mode, do one of the following:

●

Start note input.

● Select the notes to which you want to add an octave line. If you want to add an octave

line for a single voice, only select notes in that voice.

2. In the Notations toolbox, click Clefs to show the Clefs panel.

3. Input the octave line you want in one of the following ways:

●

To input an octave line for all voices on the staff, click it in the Clefs panel.

●

To input an octave line only for the currently selected voice, Alt -click it in the Clefs

panel.

Alternatively, when adding octave lines to existing notes, you can click the octave line you

want in the Clefs panel rst, and then click and drag it to the length you want.

RESULT

During note input, octave lines are input at the caret position. However, if you input notes using

the mouse, octave lines do not automatically extend as you continue inputting notes.

When you add octave lines to existing notes, they are added either above or below your

selection, depending on whether the octave line indicates that notes are played higher or lower

than notated.

TIP

You can also lengthen/shorten octave lines after they have been input.