User manual

TIP
The two notes can be in different voices.
2. Press Shift-O to open the ornaments popover.
3. Enter the appropriate entry for the glissando line you want into the popover.
●
Enter gliss for a straight glissando line.
●
Enter glisswavy for a wavy glissando line.
4. Press Return to close the popover.
RESULT
If you selected two notes, the glissando line specied is input between the selected notes.
If you selected a single note, the glissando line specied starts from the selected note and ends
at the next note in the same voice on the staff, even if this crosses rests.
NOTE
●
You cannot input a glissando line on the last note on a staff.
●
Glissando lines do not automatically adjust around any notes or rests between the selected
notes. If glissando text is shown, the text can collide with notes or rests, in which case we
recommend that you make further adjustments, such as not showing glissando text for that
glissando line.
RELATED LINKS
Ornaments popover on page 252
Glissando lines on page 673
Changing glissando line text on page 675
Changing when glissando line text is shown on page 675
Inputting glissando lines with the panel
You can input glissando lines between existing notes using the Ornaments panel. You can input
glissando lines between both adjacent and non-adjacent notes.
NOTE
● These steps describe inputting with the default mouse input preference Create item at
selection.
If your preference is set to Load pointer with item, you can only input glissando lines
between the note you click on and the note immediately following it.
●
You cannot input glissando lines during note input.
PROCEDURE
1. In Write mode, select one of the following:
●
The note from which you want a glissando line to start.
●
Any two notes that you want to join with a glissando line.
TIP
The two notes can be in different voices.
2. In the Notations toolbox, click Ornaments to show the Ornaments panel.
Write mode
Notations input
259
Dorico SE 3.1.10