User manual

Table Of Contents

EXAMPLE

Default repeat ending structure with two

endings

Repeat ending structure with additional third ending

RELATED LINKS

Repeat endings on page 748

Inputting repeat markers with the popover

You can input repeat markers, including repeat jumps and repeat sections, using the repeats

popover, both during note input and by adding them to existing music.

PROCEDURE

1. In Write mode, do one of the following:

● Start note input.

TIP

During note input, you can select additional notes before/after the last input note

without deactivating the caret by pressing Shift-Right Arrow / Shift-Left Arrow .

● Select an item at the rhythmic position where you want to input a repeat marker.

For repeat jumps, we recommend that you select the barline with which you want the

end of the jump instruction to align. For repeat sections, we recommend that you select

the barline with which you want the start of the section marker to align.

2. Press Shift-R to open the repeats popover.

3. Enter the appropriate entry for the type of repeat marker you want into the popover.

For example, enter coda to input a coda section or enter $ to input a segno.

4. Press Return to close the popover.

RESULT

During note input, repeat markers are input at the caret position. Coda sections are

automatically formatted so that there is a gap between the coda and the preceding material.

When adding repeat markers to existing music, repeat markers are input at the rhythmic

position of the earliest selected item.

Repeat markers that indicate the end of a section, such as Fine and D.C. al Coda, are right-aligned

with the selected rhythmic position.