User manual

Table Of Contents

Changing the start count of bar repeats

You can change the number from which individual bar repeats start, for example, if you want to

notate the

rst bar in a repeated phrase at the start of each system but show a continuous count

across multiple bar repeats.

NOTE

●

The start count applies to the rst bar in the bar repeat, which is the notated bar. For

example, changing the start count of a one-bar repeat region lasting three bars to 5, with

bar repeat counts shown every four bars, causes the count at the end of the bar repeat

region to show the number 8.

●

Bar repeat counts are only shown on one-bar repeat regions.

PROCEDURE

1. Select the one-bar repeat regions whose start count you want to change.

2. In the Properties panel, activate Count from in the Bar Repeat Regions group.

3. Change the value in the value eld.

RESULT

The number and position of bar repeat counts on the selected bar repeats is changed. For

example, changing the start count from 1 to 2, with counts shown every four bars, causes the

count to appear on the second bar in the bar repeat region instead of the third.

EXAMPLE

Separate bar repeats on multiple systems in the

same part layout with the default count

Separate bar repeats on multiple systems in the

same part layout with their counts changed to imply

a continuous region