User manual

Table Of Contents

Changing the start count of slash regions

You can change the number from which individual slash region counts start, for example, if you

want to input more precise notation between two slash regions but want the count to appear to

continue across the regions.

PROCEDURE

1. Select any part of each slash region whose start count you want to change.

2. In the Properties panel, activate Count from in the Slash Regions group.

3. Change the value in the value eld.

RESULT

The number and position of counts on the selected slash regions is changed. For example,

changing the start count from 1 to 2, with counts shown every four bars, causes the count to

appear on the third bar in the slash region instead of the fourth.

EXAMPLE

Two separate slash regions, where the start count on the second region has been changed so it appears to

continue on from the rst region.

Changing the slash region count frequency

You can change how frequently counts are shown on slash regions individually, for example, if

you want to show the count after eight bars on a single slash region. By default, slash region

counts are shown every four bars.

PROCEDURE

1. Select any part of each slash region whose count frequency you want to change.

2. In the Properties panel, activate Count frequency in the Slash Regions group.

3. Change the value in the value eld.

RESULT

The count frequency is changed for the selected slash regions.