User manual

Table Of Contents

To avoid this, Dorico SE changes the vertical position of ties slightly, and makes small changes to

the curvature of ties. These changes are small, but the placement of ties is subtly different

depending on the position of notes relative to staff lines.

A tie outside noteheads When transposed one note down, the tie appears

with a steeper curve to avoid reaching its apex on

the staff line.

A tie between noteheads, with the ends slightly

above the vertical center of the noteheads to avoid

the tie appearing too close to the staff line at its

ends or apex.

When transposed up, the ends of the tie are now

positioned at the vertical center of the notehead, as

there is no staff line with which it could collide.

Wherever possible, clef changes should not be positioned in the middle of tie chains. Changing

the clef changes the position of the tied note on the staff, which could easily cause a performer

to misread the tie as a slur and play two different notes.

Ties can look distorted when they are very short, and can be overlooked.

NOTE

Slurs must not be confused with ties, which look supercially similar, but instead join notes of the

same pitch to indicate that they are played as a single note. In that sense, ties are part of

rhythmic notation, while slurs are considered articulation.