User Manual

WAVELAB
Master Section 10 – 237
Loading a preset
To load a preset, select it in the list to the left, and click on one of the Load
buttons, depending on the desired load method:
• The Replace method replaces all settings in the Master Section with the setting in
the preset.
• The Mask method replaces only those slots in the Master Section that are actually
used in the preset.
• The Append method fills the unused slots in the Master Section with the settings
in the preset.
If there are not enough free slots available to load the entire preset, a warning message will
appear.
Modifying a preset
1. Set up the Master Section as desired.
If you only want to adjust a few settings in an existing preset, you may want to load this first,
as described above.
2. Go back to the “Master Section Presets” window.
3. Select the preset you want to overwrite with the new settings.
4. Click the Update button.
• To update settings for the last loaded preset you can [Ctrl]-click the Pre-
sets button.
This will save any changes without having to open the dialog.
Deleting a preset
To delete a preset, select it in the list to the left and click the Delete button.
Using key sequences for presets
If you want to invoke a preset via a key command sequence, you can do
this by defining key sequences.
A key sequence contains between one and three keys that must be
pressed in a certain order to recall the preset.
Defining key sequences
1. Select the preset for which you want to create a key sequence, and click
the key sequence button.
2. If you want to clear the current key sequence, click Clear.