User Manual

WAVELAB
Generating signals 26 – 645
Proceed as follows:
1. Select the Audio Signal Generator option on the Tools menu.
2.
Decide on a number of layers, by setting the “Number of layers” para-
meter at the bottom of the dialog.
You can always change this value at a later stage if required.
3. Select one of the layers, using the “Edit layer” parameter.
4. Decide if you want to make changes for both or just one of the channels in
this layer, by using the “Edit channel(s)” pop-up.
5. Make the required settings on the Source, Frequency and Level tabs.
Click the question mark icon in the dialog for details. Please note that the length of the file
is determined by settings on the Level tab.
6. Repeat steps 3 to 5 as required.
7. When everything is done, set up a file format and Global level in the mid-
dle section of the lower half of the dialog.
8. Click Generate.
The file is generated and opens up in a new window.
The algorithms that the Audio Signal Generator is based on were optimized
for accuracy, not for speed. Creating long and/or complex files might take a
while, especially on slower computers.