User Manual

WAVELAB
28 – 664 Using samplers and creating loops
Receiving samples
1. Pull down the Sampling menu and select “Receive…”.
2. Select the desired sampler from the Target menu.
As with Transmit, this menu lists the samplers for which you have created presets.
3. If the protocol used for this sampler identifies samples by number, use the
“Sample number” setting to specify which sample to retrieve.
4. If the sampler uses names and/or banks, click the Refresh button to get a
list of the current memory contents in the sampler. Then select a bank and
a sample location from the pop-up and list.
5. Click Receive.
The sample is received and opened in a new window. You can monitor the progress of the
reception on the status bar at the bottom of the screen.
About loops
If the sample contains loops they will be converted to loop markers in
WaveLab. However, see “About loops” on page 660.
Deleting and getting information about samples
In the Transmit and Receive dialogs, you will find Info and Delete buttons.
These buttons will only be available for samplers where a specific proto-
col that supports this functionality is implemented. They are not available
with the generic protocols SDS and SMDI (see “Generic SDS (Sample
Dump Standard)” on page 658).
1. If required, click Refresh to update the list of samples in the sampler.
2. Select a bank and sample in the list.
3. Click Delete to remove the sample from memory, or click Info to get infor-
mation about the properties of a sample.