User Manual

WAVELAB
Plug-in Processor Reference 33 – 769
Choirus2
Choirus2 is a chorus effect, used for making the sound “warmer”, etc. It
has the following parameters:
Parameter Description
Time Use this parameter to specify the basic time delay for the chorused sig-
nal with respect to the “dry” signal. The higher the value, the more pro-
minent the effect. Low settings create flanger-like effects, medium
settings provides classic chorus while higher settings are mainly for
special effects.
Width Use this parameter to specify how much the delay time is allowed to
vary with the modulation. It is this variation in delay time that causes the
sweeping effect. Note that the value 0% should probably be avoided
since it might create the impression that you are experiencing phase
problems.
Lfo Freq The Frequency parameter sets the speed of the sweep (the modula-
tion). The higher the value, the faster the modulation. You will probably
not use higher values (above 7Hz) except for special effects.
Feedback This parameter specifies how much of the output from the effect is fed
back to the input (the feedback signal is also phase inverted). The
higher the value, the more prominent the effect. At short delay times, this
creates a flanger-like effect. At larger settings it creates more of a slap-
back repetition type of sound.
Feed Bal Use this parameter to set the volume of the Feedback signal (see
above) in the mix. If this is set to 100%, and combined with a Feedback
setting between 65% and 100%, the effect goes into self-oscillation.
Glimmer 1,
Glimmer 2
The two Glimmer parameters allow you to specify to what extent the
Chorus signal should move around in the stereo image. They work in
more or less the same way as the Auto Panner but only apply to the
Chorus signals. Glimmer 1 processes the right channel signal, while
Glimmer 2 processes a combination of the left and right channels (the
actual left channel always remains at 0).
Out Levl The stereo output level of the effect.