User Manual

Editing Zones
Voice Control Section for Organ Zones
99
Glide Time
Sets the glide time, that is, the time it takes to bend the pitch from one note to
the next.
Sync
Activate Sync to synchronize the delay time to the host tempo. Select a note value
from the pop-up menu. To change the selected note value to a triplet, activate the
T button.
Mode
• Set this parameter to Constant Time to keep the glide time constant and
independent from the note interval.
• Set this parameter to Constant Speed to change the glide time with the
note interval. Larger intervals result in longer glide times.
Curve
Allows you to select one of three curve types to define the glide behavior.
• With the Linear curve, the pitch glides at continuous speed from the start
to the end pitch.
• With the Exponential curve, the pitch starts gliding at higher speed and
decelerates towards the end pitch. This behavior is similar to the natural
pitch glide produced by a singer.
• With the Quantized curve, the pitch glides in semitones from the start to
the end pitch.
Glide Group
If you assign zones to glide groups, you can set the glide effect independently
for the zones. This allows you to set up zones with overlapping key ranges and
different settings of Glide Time, for example.
Use Start Range
If a new note plays in a different zone with a different sample assigned, the new
sample is used to glide to the new pitch. Depending on the sample, this can
produce an unnatural attack. To avoid this, activate Use Start Range. If this is
activated, the sample does not start from the beginning, but from the position you
set with the Sample Start Range parameter.
RELATED LINKS
Voice Groups on page 89
Sample Oscillator Section on page 106
Voice Control Section for Organ Zones