Quick Start Guide

Preparation before using with a computer
12 UR-RT4/UR-RT2 Startup Guide
NOTICE
• Setting the [ ] switch to on and
standby in rapid succession can cause
it to malfunction. After setting the [ ]
switch to standby, wait for about six
seconds before setting it to on again.
• To avoid generating unwanted noise,
make sure there is adequate distance
between the power adaptor and the
device.
Preparation before
using with a computer
The following preparations are required
before you can use the device with a
computer.
• Installing TOOLS for UR-RT
• Activating Basic FX Suite
• Downloading Cubase AI (DAW)
Installing TOOLS for UR-RT
Follow the steps below to install the TOOLS
for UR-RT.
NOTE
• You are only permitted to use this software
pursuant to the terms and conditions of the
“License Agreement” shown during the
installation.
• Future upgrades of application and system
software and any changes in specifications
and functions will be announced at the
following website.
http://www.steinberg.net/
• The eLicenser Control Center (eLCC) for
controlling the product license is installed at
the same time.
Windows
1. Make sure that the computer is off
and the [ ] switch is in the
standby position (N).
2. Disconnect all USB devices other
than the mouse and keyboard
from the computer.
3. Start the computer and log on to
the Administrator account.
Exit any open applications and close
all open windows.
CAUTION
• Even when the [ ] switch is
in the standby position,
electricity is still flowing to
the unit. If you do not plan to
use the unit for a while, be
sure to unplug the AC
adaptor from the outlet.
• Before turning the [ ]
switch on or standby for all
devices, set all volume levels
to minimum.