User Manual

Using the UR22mkII
UR22mkII Operation Manual 10
Using the UR22mkII
Connections
This section covers instructions for connecting a
microphone and an electric guitar to the UR22mkII
with a computer.
1. Confirm that the output level of the
[OUTPUT] and [PHONES] knobs are set to
the minimum.
CAUTION
Make sure that you set all volume levels to minimum
before connecting or disconnecting the external
device. Otherwise, high-volume output may damage
your hearing or the equipment.
2. Confirm that the [+48V] and [INPUT 2 HI-Z]
switches are off.
NOTICE
Do not connect or disconnect any cables while turning
on the [+48V] switch and the [INPUT 2 HI-Z] switch.
Doing so can damage the connected device and/or the
unit itself.
3. Move the [POWER SOURCE] switch on the
rear panel to the [USB2.0] side.
4. Connect the device directly to the computer
by using the included USB cable.
NOTE
• Make sure that only one device compatible with Yamaha
Steinberg USB Driver is connected.
• (Windows only) Connect the USB cable to the same USB
terminal that you used when installing the Yamaha
Steinberg USB Driver. If you connect the USB cable to a
different USB terminal, the Yamaha Steinberg USB Driver
will be installed again.
5. Connect a microphone to the [MIC/LINE 1]
jack.
6. Connect an electric guitar to the
[MIC/LINE 2] jack.
7. Turn the [INPUT 2 HI-Z] switch on.
8. Turn the [+48V] switch on when using a
condenser microphone which requires
phantom power.
The connection for a microphone and an electric
guitar are now complete. For the connection for
other devices such as an iPad, refer to the
connection examples.