User's Manual

Appendix
UR22C Operation Manual 34
Signal Flows
The following chart indicates the signal flow in the device.
NOTE
• The controllers on the device, such as the [INPUT GAIN] knobs, [OUTPUT] knob are not included in this chart.
• To configure each parameter, use the “dspMixFx UR-C” (page 8) or “Dedicated Windows for Cubase Series” (page 13).
• Please note that you cannot use the built-in Guitar Amp Classics when the sample rate is set to 176.4 kHz or 192 kHz.
*1 The following chart indicates an effect insertion location.
LOOPBACK OFF/ON
From
[MIC/LINE 1]
From
[MIC/LINE 2]
*1
Insert FX
SLOT1
SLOT2
Insert FX
SLOT1
SLOT2
To
[MIDI OUT]
From
[MIDI IN]
To DAW input
From DAW output
USB
To [MAIN OUTPUT]
To [PHONES]
MIX 1
REV-X
REV-X
Send
Level
REV-X
Send
Level
REV-X
Return
Level
FX REC (OFF)
To DAW input
From input on the device
To output on the device
FX REC (ON)
From input on the device
To output on the device
To DAW input
Insert FX
SLOT1
SLOT2
Insert FX
SLOT1
SLOT2
• Set FX REC ON when recording the DSP effect processed signal with the DAW.
• Set FX REC OFF when recording a signal without DSP effect processing with the DAW.