User Manual

Software

UR816C Operation Manual 15

Effect Settings area

This area is used to set parameters related to the UR816C

input/output port effects.

1 Pre/Post

Used to select the insertion point for the effect.

2 Effect Name

Displays the names of the applied effects.

3 Effect Bypass

Enables/bypasses the effect.

4 Effect Edit

Displays the Effect Edit window.

5 Effect Type

Selects the effect type.

Settings: No Effect, Morphing Ch Strip ([m] or [s]), GA Classics -

CLEAN, GA Classics - CRUNCH, GA Classics - LEAD,

GA Classics - DRIVE

NOTE

The maximum number of Channel Strip and Guitar Amp Classics

iterations which can be used simultaneously is limited. Refer to

the “Limitations on the use of effects” (page 36).

6 REV-X Send

Adjusts the signal level which is sent to REV-X.

Range: -∞ dB – +6.00 dB

7 REV-X Name

Displays the selected REV-X type.

8 REV-X Edit

Opens the “REV-X” (page 19) setup window.

9 REV-X Type

Selects the REV-X type.

Settings: Hall, Room, Plate

Outputs area

This area is used to set parameters related to hardware

outputs.

1 Mix Bus name

Displays the Mix Bus name of the hardware output. The

output bus of the track must be connected to this Mix bus.

2 Output meter

Displays meters for the hardware Mix Bus connected to

hardware outputs.

3 Meter Clip

Displays the input meter clip when clipping occurs. Click

this to stop this display.

4 Headphones

Patches headphones to the hardware Mix Bus connected

to hardware outputs.