User Manual

Using the Device without Computer
UR816C Operation Manual 29
Using the Device without
Computer
This section shows how to use the device without a
computer, allowing you to use it as a standalone mixer or
AD/DA converter. You can save the DSP mixer and DSP
effect settings configured by the dspMixFx UR-C to the
device. These settings are maintained even if you turn off
the power of the device.
WARNING
Make sure that you set all volume levels to minimum before
connecting or disconnecting the external device. Otherwise,
high-volume output may damage your hearing or the
equipment.
Connection Example
Operation
1. Connect the device to a computer with a
USB cable.
2. Turn on the UR816C.
3. Open the dspMixFx UR-C.
For instructions on opening the dspMixFx UR-C,
refer to the “How to Open the Window” (page 8) in
the section “dspMixFx UR-C.”
4. Configure the DSP mixer and DSP effect
settings.
5. When you make the settings, click [X] on the
upper left of the window to close the
dspMixFx UR-C.
The settings of the dspMixFx UR-C are saved to the
device.
6. Disconnect the device from the computer.
The operation is now complete.
Microphone
GuitarBass
Monitor speakers
Synthesizer
UR816C rear panel
UR816C front panel