User Manual

Appendix
UR816C Operation Manual 38
*1 The following chart indicates an effect insertion location.
*2 One of the MIX 1to 4 signals can be sent to the REV-X.
*3 The built-in REV-X is equipped with an “FX Bus” which is used for sending the signal from DAW software to the REV-X. For
example, to send the recorded audio data to the REV-X, you can check the sound with the REV-X, which is used for
monitoring during the recording.
*4 The LINE OUTPUT and OPTICAL OUT can be output not only to MIX 1 to 4 but also with the recording signal of each
input channel and the DAW signal. For details, refer to the “OUTPUT ROUTING” (page 12) in the section “dspMixFx
UR-C” and the Block Diagrams (page 39).
FX REC (OFF)
To DAW input
From input on the device
To output on the device
FX REC (ON)
From input on the device
To output on the device
To DAW input
Insert FX
SLOT1
SLOT2
Insert FX
SLOT1
SLOT2
• Set FX REC ON when recording the DSP effect processed signal with the DAW.
• Set FX REC OFF when recording a signal without DSP effect processing with the DAW.