Instructions

- 30 - - 31 -- 30 -
10. Technical specifications
IR180UPeasy IR180APeasy
Dimensions (H×W×D) 81×81×57mm 82×72×67mm
Power supply 220-240V, 50/60Hz
Power consumption 25mW
Output
Incandescent / halogen lamp load
Fluorescent lamps, electronic ballast
Fluorescent lamps, uncorrected
Fluorescent lamps, series-corrected
Low-voltage halogen lamps
LED < 2 W
2 W < LED < 8 W
LED > 8 W
Capacitive load
200W
150W
150VA
150VA
200VA
40W
100W
160W
132µF
Minimum connected load with N: 1W
without N: 4W
Mounting height 1.1m
Sensor system Passive infrared
Angle of coverage 180° with 90° angle of aperture
Reach Max. 8 m tangential
Twilight setting 2-1000lux
Time setting 5 s - 30min
Temperature 0°C to +40°C
IP rating IP20 IP54
11. Troubleshooting
Malfunction Cause Remedy
Sensor switchWithout
voltage
■ Fuse has tripped, not
switched ON
■ Short circuit
■ Activate, change fuse,
turn ON mains switch,
checkWiringWith
voltage tester
■ Check connections
Sensor switch not
switching ON
■ Lamp faulty ■ replace lamp
Sensor switch not
switching ON
■ Twilight setting in night-
time mode during
daytime operation
■ Fuse has tripped
■ Reset
■ Activate, change fuse,
check connection if
necessary
Sensor switch not
switching OFF
■ Continued
movementWithin the
detection zone
■ Light is in detection zone
and keeps switching ON
as a result of
temperature change
■ Other sensor switch is
connected in parallel and
still active
■ Check detection zone
■ Check detection zone
■ Wait for time setting of
the other sensor switch
to elapse
Sensor switch always
switches ON/OFF
■ Light being operated in
the detection zone
■ Animals moving in
detection zone
■ Check detection zone
■ Check detection zone
LEDs glowing, flickering ■ LEDs responding too
sensitively
■ Connect neutral
conductor (N), change
lamp