User manual

- 26 - - 27 -
10� Technical specifications
Dimensions (H x W x D) 81 x 81 x 57 mm
Power supply 220 - 240 V, 50 / 60 Hz
Power consumption 25 mW
Output
Incandescent / halogen lamp load
Fluorescent lamps, electronic ballast
Fluorescent lamps, uncorrected
Fluorescent lamps, series-corrected
Low-voltage halogen lamps
LED < 2 W
2 W < LED < 8 W
LED > 8 W
Capacitive load
200 W
150 W
150 VA
150 VA
200 VA
40 W
100 W
160 W
132 µF
Minimum connected load with N: 1 W
without N: 4 W
Mounting height 1.1 m
Sensor system Passive infrared
Angle of coverage 180° with 90° angle of aperture
Reach max. 8 m tangential
Twilight setting 2 - 1000 lux
Time setting 5 sec - 30 min
Temperature 0°C to +40°C
IP rating IP20
11� Troubleshooting
Malfunction Cause Remedy
Sensor switch without
voltage
■ Fuse has tripped, not
switched ON
■ Short circuit
■ Activate, change fuse,
turn ON mains switch,
check wiring with voltage
tester
■ Check connections
Sensor switch not
switching ON
■ Lamp faulty ■ replace lamp
Sensor switch not
switching ON
■ Twilight setting in night-
time mode during
daytime operation
■ Fuse has tripped
■ Reset
■ Activate, change fuse,
check connection if ne-
cessary
Sensor switch not
switching OFF
■ Continued movement
within the detection zone
■ Light is in detection zone
and keeps switching ON
as a result of tempera-
ture change
■ Other sensor switch is
connected in parallel and
still active
■ Check detection zone
■ Check detection zone
■ Wait for time setting of
the other sensor switch
to elapse
Sensor switch always
switches ON/OFF
■ Light being operated in
the detection zone
■ Animals moving in detec-
tion zone
■ Check detection zone
■ Check detection zone
LEDs glowing, flickering ■ LEDs responding too
sensitively
■ Connect neutral conduc-
tor (N), change lamp