User manual

- 18 - - 19 -
Button for light functions
Troubleshooting
Malfunction Cause Remedy
Sensor Switch
without power
Fuse blown,
not switched ON
Short circuit
Replace fuse; switch
ON mains switch;
check wiring with
voltage tester
Check connections
Sensor Switch
does not switch ON
Twilight setting in
night-time mode dur-
ing daytime operation
Additional two-way
switch OFF
Fuse blown
Readjust
Switch power on
New fuse, check con-
nection if required
Sensor Switch
does not switch OFF
Continued movement
within the detection
zone
Switched ON light is
within detection zone
of IR 180 UP and
switches ON again as
a result of tempera-
ture change
Permanent light op-
eration switched ON
(red LED illuminates)
Other Sensor Switch
is parallel-connected
and still active
Check detection zone
Check detection zone
Switch off permanent
light operation
Await time setting
of the other Sensor
Switch
Sensor Switch
keeps switching ON/OFF
Switched ON light
is within IR 180 UP
detection zone
Animals moving in
IR 180 UP detection
zone
Curtains, owers,
etc. move within the
detection zone of the
HF 360 UP and cause
switching again by
motion
Check detection zone
Check detection zone
Check detection zone
Sensor Switch
does not switch ON
Light bulb burnt out Replace light bulb
Sensor mode
The Sensor Switch basically operates in sensor
mode. The light is switched ON for the preset
time in response to movement within the
detection zone.
Permanent light mode
Button 1 x ON
The connected light is set to permanent light
for 4 hours (red LED illuminates). After this
period, the Sensor Switch immediately returns
to sensor mode (red LED OFF).
Permanent light can be interrupted before
this time elapses by pressing the button
(red LED OFF).
Permanent light OFF mode
Press button for 3 sec.
The connected light is switched OFF
(red LED fl ashes).
By briefl y pressing the button again, the Sensor
Switch returns immediately to sensor mode
(red LED OFF).
1 x 3 sec.
OFF
1 x short
max. 4 hours
Sensor
5 sec. - 30 min.