assembly Instructions

– 17 –
– 16 –
Malfunction Cause Remedy
Sensor-switched LED floodlight
without power
Fuse faulty; not switched ON;
break in wiring
Short-circuit
New fuse, turn on power switch,
check wiring with voltage tester
Check connections
Sensor-switched LED floodlight
will not switch ON
Twilight setting in night-
time mode during daytime
operation
Mains switch OFF
Fuse faulty
Detection zone not correctly
adjusted
Reset
Switch ON
Replace fuse, check connection if
necessary
Readjust
Sensor-switched LED floodlight
will not switch OFF
Continued movement within
the detection zone
Check zone and readjust if
necessary or apply shroud
Sensor-switched LED floodlight
keeps switching ON and OFF
Animals moving in detection
zone
Tilt sensor higher or apply specific
shrouds; adjust detection zone or
fit shrouds
Sensor-switched LED floodlight
switches ON when it should not
Wind is moving trees and
bushes in the detection zone
Cars in the street are detected
Sudden temperature changes
due to weather (wind, rain,
snow) or exhaust air from fans
or open windows
Sensor-switched LED
floodlight swaying (moving),
resulting, for example, from
gusts of wind or heavy
precipitation
Change detection zone
Change detection zone
Adjust detection zone or install in
a dierent place
Fit sensor-switched LED flood-
light to a firm surface
The device cannot be added
(and is not yet added)
Z-Wave controller too far from
the device
Reduce distance from Z-Wave
controller
Install a Z-Wave repeater
The device cannot be added
It is already added Remove device from existing
network
Carry out default reset
Status-LED
flashing for
1 second every 5 seconds
No wireless contact with the
Smart Friends Box or other
Z-Wave controller
Re-start Smart Friends Box or
Z-Wave controller
Reduce distance from Z-Wave
controller
Install a Z-Wave repeater
Status LED
flashing rapidly
all the time
Critical fault Briefly disconnect device from the
mains power supply
12� Troubleshooting
Dimensions (H×W×D) 194×180×161
Output 14.8 W / 80 lm/W
Luminous flux / brightness 1184 lm
Weight 0.575 kg
Area illuminated Front view 283.1 cm
2
Side view 113 cm
2
Mains current 75mA
Power factor max. 100 W (resistive load, e.g. light bulbs)
max. 500 W (uncorrected, inductive, cos
= 0.5, e.g. fluorescent lamps)
max. 4 × 56 W, C ≤ 88 μF
Eciency 80 lm/W
Colour temperature 4000 K (neutral white)
Colour rendering index Ra ≥ 80
Supply voltage 230-240 ~V / 50/60 Hz
Sensor system Passive infrared
Reach max. 14 m via control dial
Angle of coverage 140°
Time setting 3 min factory setting / 1 s to 15 min with the app
Twilight setting 2-2000 lux via control dial and with the app
IP / protection class IP44 / II
Z-Wave wireless range approx. 100 m (unobstructed line of vision)
Radio frequency band 868 MHz
Transmitter power ≤ 2.5 mW
The warranty shall not cover damage to wear parts,
damage or defects caused by improper treatment
or maintenance. Further consequential damage to
other objects shall be excluded.
Claims under the warranty will only be accepted
if the unit is sent fully assembled and well-packed
with a brief description of the fault, a receipt or
invoice (date of purchase and dealer's stamp) to
the appropriate Service Centre.
Service
Our Customer Service Department will repair faults
not covered by the warranty or after the warranty
period has expired. Please send the product well-
packed to your nearest Service Centre.
11� Technical specifications
GB