User manual

Basic instructions for use

222

333

444

555

111

666

Attaching the belt attachment:

With ClicLoc System:

To loosen the carrying strap and unlatch the lock, press and hold the release button

111

. The snap

fit can now be pulled off and/or inserted. Make sure that the catch is always facing outwards

and that it audibly engages while being inserted.

Without ClicLoc system:

Please loosen one end of the strap from the side loop and feed the strap from the top through

the eyelet.

222

Now pull the carrying strap through the slide loop again and pull firmly on the

strap to tighten it. Repeat these steps to fasten the other end of the strap in the same way.

Attaching the neoprene protection cover and the rain protection cover:

Several rain protection systems may be enclosed with your binoculars that are attached to the

carrying strap. For neoprene protection covers, please ensure that the semicircular opening

on the cover is placed over the focussing wheel

333

For rain protection covers, the strap

retainer may be threaded laterally through the open eyelet

444

provided for this purpose.

Attaching the objective protection covers:

If your binoculars are equipped with locking ClicLoc objective protection covers, press on the

visible depression to release the cover and pull it out of its retainer

555

. To re-connect it, push

the snap-on fastener back into the retainer until it is secure and audibly engages. Objective

protection covers that are attached to the centre axis are removed by pulling them over the

centre axis

666