Instructions / Assembly

4
INSABA1116
SINGLE BASEBOARD WIRING
The baseboard can be wired to a power supply from either
end. Remove twist-on connector from selected junction box
and secure the power leads.
MULTIPLE BASEBOARDS WIRING*
Power connections can be made in either junction box of any heater.
*Ground continuity must be maintained between heaters that are physically
joined to each other and that are supplied from the same branch circuit.
USING UNIVERSAL CABLE CLAMP INSTALLATION WITH EMT CONDUIT
INSTALLATION & MAINTENANCE
L.H. junction box R. H. junction box
Element
(R)
Ground screws (green)
Power supply
Linear control
L.H. junction boxR. H. junction box
Element Element
(R
)(
R)
Ground screws
(green)
Ground screws
(green)
Power supply
Linear control
ELECTRICAL WIRING
N.B. The unit should be cleaned at least once a year. All other
servicing is to be done by qualied service personnel. This unit
must be cleaned regularly In order for the warranty to be valid.
Make sure the power has been turned off at the circuit breaker
panel and that the heating element has cooled before cleaning the
unit or before removing front panel for cleaning and lubrication.
Use a soft rag for dusting. When cleaning, use only a damp rag and
non-abrasive dish soap. If you use a cleaning product, always wipe
the product off properly to avoid the discoloration of the unit. Do not
use abrasive or chemical cleaners because they may damage the
nishing. If the unit is used in a very dusty location, use a vacuum
brush to remove dust and other foreign objects from the grilles. Note
that cigarette smoke could yellow the discharge grille and that the best
way to prevent it is to clean the unit on a regular basis.
Don’t forget to replace front panel (with the screws that were removed)
if it was removed for cleaning. Restore the power when cleaning or
lubrication work is complete.
WARNING
Do not use cleaning products identied with these symbols:
N.B. Note that there is electrical current linked to the unit even if
the thermostat is set off. This means that there is a risk of electric
shock as long as the unit is energized.
MAINTENANCE