Instructions / Assembly

3
INSAMIR1017
N.B. Cut off power supply at circuit breaker/fuse before proceeding to the installation.
- The unit should be installed at least 4 in (10.2 cm) from the oor and 6 in (15 cm) from adjacent walls. However, make sure objects or pieces of furniture such as,
but not limited to, blankets, towels, beds, laundry baskets, clothing, papers, etc. do not come into contact with the unit and keep them at least 12 inches (30.5 cm)
from the unit since they are more ammable than walls and oors. Failure to comply with this warning could lead to a re. Some materials are more heat-sensitive
than others, so make sure those near the unit can withstand heat.
- Before operating the unit, make sure that both the air inlet (bottom) and air outlet (front) are free from obstruction.
INSTALLATION
INSTALLATION OF THE WALL RACK
1. Remove the unit from the wall rack’s hooks.
2. Put the bracket on the oor, on the wall where the appliance is installed and draw a
temporary line under the horizontal line of the bracket using a pencil. (FIGURE 1)
3. Align bottom of wall bracket with the temporary line drawn in the previous step. (FIGURE 2)
4. Make marks with a pencil to identify the four areas where you will screw the bracket.
5. Secure the bracket to the wall making sure it is level. When drilling the wall, make sure
not to damage electrical wiring and other hidden utilities.
N.B. The wall where you install the device must be straight so that the
bracket is perfectly level, without any pressure. It is very important to
follow this directive to prevent damaging the bracket during the instal-
lation. This could cause malfunction of then interlock system.
INSTALLATION FOR 120V PRODUCT ONLY:
Secure the bracket to the wall making sure it is level using screws (minimum head size
1/4“(6.5 mm) in diameter) and appropriate anchors depending on wall type and product
weight (18lbs).
FIGURE 1 FIGURE 2
FIG. 2
LINE DRAWN IN PENCIL
DRAW LINE IN PENCIL
HERE
FLOOR
FLOOR
FIG. 1
TECHNICAL DRAWINGS
34mm
1 5/16"
4"
102mm
#
#
FRONT
MIN
457mm
18"
276mm
10 7/8"
KO Ø7/8 2X
[22mm]
2 7/8"
73mm
TOP
LENGHT
2 7/8"
73mm
SIDE
9/16"
14mm
3 5/8"
92mm
TECHNICAL DRAWINGS AND INSTALLATION
HANGING THE UNIT ON THE WALL BRACKET
1. Insert the lower hooks of the wall bracket in the device. (FIGURE 3)
2. Tilt the top of the unit and snap it. (FIGURE 4)
3. Push the unit to secure it. (FIGURE 5)
4. The unit must be mounted at least 4 inches (10.2 cm) from the oor.
(FIGURE 6)
REMOVING THE UNIT FROM THE WALL RACK
1. Using a screwdriver, press on each clip. (FIGURE 7)
2. Pull the upper part of the unit toward you to disengage the hooks.
3. Pull the unit off the lower hooks.
FIGURE 3 FIGURE 6FIGURE 4 FIGURE 5 FIGURE 7
4"
101mm
MIN.