Full Product Manual

5
INSSOA1017
ADJUSTING THE TEMPERATURE SETPOINT
- Press one of the two buttons to access the temperature setpoint
mode. The temperature setpoint digits will ash.
- The temperature setpoint is set by using the UP (
) or DOWN
(
) buttons to raise or lower the setpoint respectively by incre-
ments of 0.5 °C (1 °F) each time the buttons are pressed. Holding
down either button will allow you to scroll more quickly to the desired
temperature setpoint.
- Once the desired setpoint has been selected, release the button.
The display will stop ashing after three (3) seconds and will then
display the ambient temperature in the room.
- If the unit has a 120 V power cord, the HIGH and LOW buttons will
be red when the unit is powered.
- If the difference between the setpoint and the ambient temperature
is greater than 4°C (7°F), the unit will switch to maximum power
mode to reach the setpoint faster.
SELECTING THE OPERATION MODE
There unit has two (2) operation modes:
• NORMAL OPERATION MODE
• BOOST MODE
- In normal operation mode, the thermostat follows the setpoint and
uses the fan at low speed.
- In BOOST mode, the setpoint increases to the BOOST mode set-
point (26°C by default). When BOOST mode is activated, the fan
works faster and more powerfully to raise room temperature quickly.
Once the BOOST setpoint is reached, the fan and the power are
reduced to maintain the temperature at the BOOST setpoint.
- To activate BOOST mode, press the BOOST button. You can then
select the BOOST mode duration: 10, 20, 30 or 60 minutes.
- Once the selection is registered (after 3 seconds), BOOST mode
will continue for the determined time or until the BOOST button is
pressed again.
- Once the BOOST mode period is over, the unit will keep the fan on
to evacuate the residual heat for a maximum of 10 minutes. During
this period, the temperature setpoint is displayed and ashes.
WITH A WALL-MOUNTED THERMOSTAT
Choose a thermostat equipped with a TRIAC, which makes it possible to maintain a precise temperature, thus increasing your level of comfort.
WITH A BUILT-IN ELECTRONIC THERMOSTAT FOR SMART HOMES
OPERATION
1
The icon if the unit is overheating.
2
Displays the remaining time of the BOOST mode.
3
Displayed in advanced menus navigation.
4
Buttons used to raise or lower the temperature setpoint.
Also used to navigate in the advanced menus
5
The control lock icon
, (if applicable, see LOCKING THE
CONTROLS for more details).
6
The icon is a low setpoint indicator (7°C or lower). If the
icon is ashing, an open window has been detected and the
setpoint will be set to 7°C.
7
Ambient room temperature (or the temperature setpoint, if the dis-
play is ashing). In Boost mode, the Boost mode time remaining .
8
Heating power, by heating segments:
• 0 segments: 0 %
• 1 segments: 1-20 %
• 2 segments: 21-40 %
• 3 segments: 41-60 %
• 4 segments: 61-80 %
• 5 segments: 81-100 %
9
BOOST button.
7
6
3
4
9
5
2
8
1
DISPLAYED ITEM LISTING