Full Product Manual

6
INSSOA1017
TEMPERATURE FORMAT
The temperature can be displayed in either degrees Celsius or Fahrenheit.
Follow these steps to select the temperature format:
- Access the advanced menus.
- Select menu 1.
- Select either °C or °F.
LOCKING THE CONTROLS
This mode allows you to lock the controls in order to prevent unwanted
changes to the setpoint and/or operation modes.
NOTE: The advanced menus remain accessible at all times.
Follow these steps to activate or deactivate the control lock:
- Access the advanced menus.
- Select menu 2
.
- Select ON or OFF.
STANDBY MODE
In order to protect your home against freezing and limit energy con-
sumption during long absences, set the thermostat to STANDBY
mode. To enter this mode, lower the temperature to between 5°C and
7°C until the
icon is displayed.
OPEN WINDOW DETECTION
This unit is designed to detect an open window in the room and lower the
setpoint so as not to waste energy.
When the convector detects an open window in the room, the
icon
will ash. The setpoint will be automatically set to 7°C (45°F).
Once the convector detects that the window has been closed, the
setpoint will return to its previous setting.
Follow these steps to activate or deactivate the open window detection:
- Access the advanced menus.
- Select menu 3
.
- Select ON or OFF.
BOOST MODE SETTING
By default, Boost mode is set to 26.0°C (79°F).
However, this value can be set from 20.0°C (68°F) to 30.0°C (86°F).
Follow these steps to change the Boost mode setting:
- Access the advanced menus OR access the Boost menu directly by
pressing the “Boost” button for 3 seconds.
- Change the setting of menu 4 according to your choice.
°STELPRO MENU
Information about the unit is available in the advanced menus.
Follow these steps to access this information:
- Access the advanced menus.
- Select menu 5.
- Select one of the following sub-menus:
• 5.1: Version of unit
• 5.2: Day manufactured
• 5.3: Month manufactured
• 5.4: Year manufactured
• 5.5: Internal control code
• 5.6: Factory reset of unit
UNIT OVERHEAT DETECTION
This unit can detect when it is overheating.
If your unit’s thermal protection gets activated, an
icon will ash on
the display.
FACTORY RESET
Follow these steps to reset the unit to its factory settings:
- Access the advanced menus.
- Select menu 5.
- Select sub-menu 5.6.
- Select YES and conrm the selection.
- YES will ash for few seconds and the convector will be reset to its
factory settings.
BUTTONS MAIN SCREEN ADVANCED MENUS
HIGH BUTTON OR LOW BUTTON Set the temperature setpoint* Browse and edit settings
BOOST BUTTON Activate/deactivate BOOST mode
Select and conrm BOOST setting
(in the BOOST menu)
UP AND DOWN BUTTONS SIMULTANEOUSLY FOR 3 SECONDS Access advanced menus Exit advanced menus
BOOST BUTTON FOR 3 SECONDS
Access BOOST menu Exit BOOST menu
UP AND DOWN BUTTONS SIMULTANEOUSLY
FOR LESS THAN 3 SECONDS
--- Selection in Advanced Menus
*If the UP or DOWN button is pressed during BOOST mode, the BOOST temperature setpoint will ash for 3 seconds but cannot be changed.
BUTTON FUNCTIONS