Use and Care Manual

5
INSASOR1016
ADJUSTING THE TEMPERATURE SETPOINT
- By pressing either button on the thermostat, the temperature setpoint will be displayed as ashing digits.
- The temperature setpoint is set by using the UP ( ) or DOWN ( ) buttons to raise or lower the setpoint respectively by increments of 0.5 °C
(1 °F) each time the buttons are pressed. Holding down either button will allow you to scroll more quickly to the desired temperature setpoint.
- Once the desired setpoint has been selected, release the button. This setpoint will remain in memory for the current mode (COMFORT or ECO
( ) – see next section for details). The display will stop ashing after 3 seconds and will then display the ambient temperature in the room.
- In order to sensitize the user about energy consumption, the color of the contour around the buttons will change according to the setpoint
selected; green being a lower setpoint and red being a higher setpoint.
NOTE #1: In no heat mode, the setpoint displayed is ( -- ) and the ( ) icon is displayed indicating that there is a potential risk of freezing. In
this mode, it is not possible to modify the setpoint. If a new setpoint is sent from the smart home controller while the convector is in no heat mode,
the thermostat will return to COMFORT mode.
NOTE #2: The setpoint in ECO mode is local to the convector. In other words, its setpoint cannot be set by the smart home controller. If a new
setpoint is sent via the smart home controller while the convector is in ECO ( ) mode, the thermostat will return to COMFORT mode.
NOTE #3: If a setpoint change is sent by the smart home controller, the display will ash this setpoint on the thermostat for 3 seconds and then
return to normal.
SELECTING THE OPERATION MODE
There are three (3) operation modes: COMFORT mode, ECO mode (identied by the ( ) icon) and NO HEAT mode (identied by the ( )
icon). To switch from one mode to another, simply press and then release both buttons simultaneously
NOTE #1: If the operation mode is changed remotely by the smart home controller, the setpoint (or ( -- ) when in NO HEAT mode) will be
displayed for 3 seconds and will then return to normal.
NOTE #2: Once the ECO mode has been selected, the convector will respect the ECO mode setpoint for the duration as congured (see
ECO MODE DURATION section for details). Once the duration for ECO mode has elapsed (unless NO HEAT is selected), the convector will
automatically return to COMFORT mode.
THERMOSTAT DISPLAY
- Ambient room temperature (or the setpoint when ashing)
- Operation mode: COMFORT, ECO ( ), NO HEAT ( )
- The ( ) icon indicates a freezing risk either due to a low setpoint or if the thermostat is set to NO HEAT. This icon will ash if an open window
is detected.
- The thermostat displays the percentage of heating time required to maintain the desired temperature.
0 segments: 0%
1 segment: 1-25%
2 segments: 26-50%
3 segments: 51-75%
4 segments: 76-100%
- The status of the connectivity with the ZigBee ( ) network.
- The ( ) is displayed when the controls are locked. See LOCKING THE CONTROLS for details.
OPERATION
BUILT-IN ELECTRONIC THERMOSTAT FOR SMART HOMES (ST218)